View Links
Case Study
CS #14 - Edmond, OK 1-8DPS30 & BDC-1330LP
Date: 6/1/2018
Location: Edmond, OK
Equipment Used: 1-8DPS30 / BDC-1330LP
Case Study #8 - Springfield, Missouri
Removal of carpet glue and paint in order to clean surface with a Grinder so it could then be blasted for an epoxy coating.
Case Study #5 Line Strip Removal
Blastrac 1-10DLP used for line strip removal in Alamogordo, New Mexico.
Case Study #4 Steel Walkways at Neyland Stadium
It is football season and time to get those surfaces blasted! See what the blasting at Neyland Stadium in Tennessee...
Case Study #3 Getting the Profile Needed
Parking structure job site with a broom finish concrete preparation need and additional two inches of concrete over the top of the existing substrate and required a CSP5 profile or greater. Blason Industrial used a Blastrac 2-20D shot blaster and paired it with the Blastrac 8-54DCGI Dust collector to remove traffic and parking stall lines while leaving behind the desired profile and accomplished this in one pass...
Case Study #2 BS-110 Flooring & Coating Removal
Flooring and coating removal can be a tedious job without the proper tools and equipment. Blastrac® scrapers and strippers significantly reduce the amount of time and effort required to remove a wide range of floor coverings, waterproofing membranes and thick coatings.
Case Study #1 - Highway and Bridge Shot Blasting
This is the first of a series of case studies that Blastrac will be presenting. Please be sure to check back to see more "Down the Road". First Series is a 2-4800 Ride-On Shot Blaster in Nashville TN.